PANEL MOLDING IDEAS

“Update your house look with these panel molding ideas; this is your low cost-solution to enhance your decor!”

One easy way to enhance your decor is to add panel molding in your house.

You can get a timeless elegant look by creating frames for walls.

Sometimes the area inside the panels is finished in a different way than the rest of the wall: either is painted with a different color than the rest of the wall, or it might be used eith coordinated wallpaper.

 

Useful Tips and Tricks

    1. When measuring for panel moldings, keep in mind that spacing between panels, doors and corners should be consistent and balanced.
    1. Find the balance between what looks good and what works best for you, as there are no specific ways on what’s the width or height of your panel moldings.

molding ideas 01

    1. You can adjust the width or height of your panels depending on the place of furniture, paintings, windows, doors or electrical plugs. On the picture above you can see how the width of the panel molding was adjusted to nicely frame the doors.
    1. To estimate how much panel moldings you should buy, calculate the lineal feet for the perimeter of each room and add around 10 percent waste for miter and joint waist; round up to the nearest whole piece of molding.
    1. Paint all primed molding before you attach it to the wall: it will save you lots of time in long run and the mess paint does.
    1. Clean all surfaces free of dirt and loose particles with a clean cloth or sponge. Make sure area is completely dry before installing.
    1. It is important to establish a plan for the layout of the panels. You can choose between vertical or horizontal layout. If you have a feature wall in mind, start planning that one first.
    1. For vertical layout you can choose full height or split panels. On the picture above, two panels are full height, and the middle one is a split panel. Notice the use of the frames corners: they give more detail and definition to the wall. Some people prefer to include a chair rail also, and have panels either upper or lower the chair rails or both.
    1. Horizontal layouts can be either symmetrical or asymmetrical, with panels of the same or different sizes. One of the most used panel molding ideas: picture below shows horizontal panel molding with panels of different heights, all below the chair rail, creating wainscoting.

Steps To Install Panel Molding

 

Materials and Tools:

level, measuring tape, sandpaper, finishing nails, putty knife, hammer or miter saw, adhesive caulk, caulking gun, safety glasses

    • – Pencil mark the walls with horizontal and vertical pencil lines the height and width you want for the panels. To get a consistent height around the room, use a level to mark all the walls.
    • – Use the miter saw to cut the pieces for each panel. Cut each piece so that the panel will fit together like a picture frame.
    • – Panel corners can be mitered or you can use decorative molding corners.
    • – Apply a line of adhesive caulk along the back and top of each piece of molding to glue them in position on the wall. Secure each piece to the wall using a nail gun. If you don’t have a nail gun, you can use a hammer and 1 3/4-inch finishing nails.
    • – Work in a circle around the room to install each piece of panel molding.
  • – Apply latex caulking to joints, edges and along the edge of each piece of molding to fill any gaps between the wall and the molding. With a damp rag clean away any excess caulk and create a smooth appearance.

Leave a Reply

Your email address will not be published. Required fields are marked *