Metal Wall Tiles

With their unique sharp and modern feel, metal wall tiles will complement any kitchen or bathroom wall. Stainless steel, bronze, aluminum and copper are most common materials used.

Metal tiles or metal mosaics can come in multiple shapes and sizes, with an infinite variety of colors and finishes.
To satisfy all taste, a wide array of designs were created: brick, stack, diamond, herringbone, basket weave, parquet or checkerboard.

Tile Surfaces

Metal wall tiles surfaces can be made of:

  • Stainless steel with polished look reflects light and colour and looks good alongside vivid hues or against plain white. The brushed satin effects will soften metal reflections.
  • Copper tiles are processed with either a grained or buffed finish, allowing different grade of reflection. The surface is an orange-goldish color, that it will oxidize in time creating a rich patina. Using a copper cleaner, you can maintain original colour, or you let the copper surface change to a beautiful natural patina finish.
  • Zinc tiles processed with a mill finish can be easily grained for a desired brush finish and may be cleaned without special care.
  • Aluminum tiles are available as regular tiles or peel and stick.Lightweight, they are easy to install and maintain.

Installing Metal Wall Tiles

Things you need to install the metal tiles:soap and water, metal tile adhesive, tile spacers (optional), wet saw, acrylic latex caulk, tile sponge, nonabrasive dish scrubber, a 1/8-inch saw-toothed trowel and,of course metal tiles.

Installation steps:

  • Double-check that you have purchased enough tiles. Thoroughly clean wall for tile installation. Remove any oil, moisture or dirt.
  • Apply an adhesive suitable for metal tiles to the wall with the 1/8-inch saw toothed trowel. Allow the adhesive to set for before proceeding.
  • Use tile spacers, if desired, to control the amount of space between the tiles. Note that space is not necessary, since the tiles have beveled edges. Apply metal wall tiles with firm, steady pressure.
  • Cut tiles to fit edges using a wet saw unless the manufacturer advises otherwise. Cut tiles with the metal faces up.
  • Caulk the space between tiles using a Siliconized Acrylic Latex Caulk (available at any home construction store). Depending on the appearance, use grouted or non-sanded caulk. For high gloss tiles, use 3″ or 4″ blue masking tape on the edges of the tiles to protect the surface from scratching if you are using sand grout.
  • Remove any large deposits of the caulk with your finger Using a damp tile sponge wipe the caulk at a 45 degree angle to the tiles, use very little pressure. Rinse sponge after every stroke.
    Wipe away excess caulk with a damp tile sponge. Rinse the sponge often. Continue to wipe until the lines of caulk are smooth and there is a faint glaze over the tiles. Allow this glaze of caulk to dry for 12 hours or more
  • Let the caulk set up for at least 12 hours,then brake the glaze with a non abrasive pan scrubber and sponge clean.


    Metal mosaics have a sleek, futuristic appeal. Each mosaic is a porcelain base tile with a cut piece of stainless steel adhered to the face of the tile. Shapes vary from round penny, deco to honeycomb.

    Care and Maintenance

    Tiles metal shiny appearance can be easily maintained by cleaning with a damp cloth or sponge and solution of warm water and dishwashing detergent is sufficient.Copper may be cleaned or polished using any of the copper and brass cleaners commonly found on the market, the same applying for stainless steel.

    Return to Wall Tile Panelling from Metal Wall Tile
    Return to Home Page from Metal Wall Tiles

    Copyright © 2006-2009 Art for Your All Rights Reserved.